4 Channels PLC Power Amplifier Solenoid Valve Driver Board PNP Output

Description

Fully compatible with Mitsubishi Siemens
This model is SV-5A1R4P-P (including rail mounting frame).
Model analysis:
SV (digital signal amplifier) -5A (maximum drive current per channel 5A) -1R (one-way transmission) 4P (4 channels) -N (NPN output is drain output).
1. Module overview:
1. Use brand new imported field effect tube.
2. The input signal is compatible with NPN and PNP, compatible with PLC equipment such as Mitsubishi, Panasonic, Siemens and domestic PLC.
3. The signal input voltage is 3.3V/5V/12V/24V optional to facilitate the control of different signal generating equipment.
4. Protection measures: each input terminal adopts photoelectric isolation module to effectively protect the safety of the control terminal;
the same time, it is equipped with eight bipolar status indicators.
The output end has diode anti-surge protection, and the power supply has diode anti-reverse protection.
5. Wiring: VCC and GND are the power supply ports of this module, connect according to the prompt voltage.
COM is connected to the common pole of the signal control terminal, and 1-4 is connected to various control signals;
the output terminal of the controlled electrical appliance is an open-drain output, labeled O1-O4.
6. Installation method: DIN35mm rail installation, convenient and quick!
7. Module size: 47*86*40MM (length*width*height).
When there is a control signal, the output port Ox (O1, O2, O3...) is connected with the module's DC power supply negative (GND) to form a loop.
3. Schematic diagram of the external electrical connection of the module (each channel of this module can control electrical appliances with voltages below 30V and 5A):
输入端口
=
Input port   输出端口=
Output port
输入公共端=
Input common port
本模块电源正=
module
power supply is positive
本模块电源负=
module
power is negative
1. Manual control:
or
2. NPN output mode control such as single-chip microcomputer or PLC:
3. PNP output mode control such as single chip microcomputer or PLC: